Product introduction

Quick dry single unit with strong plastic primer，Light yellow, clear liquid. Easy to operate，Economic fitness products .The surface coating of plastic parts provides a good adhesion bridge.

Product characteristics

◆Construction is simple, without thinner, direct spraying.

◆Fast drying speed, short construction interval.

◆Versatile and suitable for most automobile plastic parts.

Physical parameters

Appearance status

Transparent and low-viscosity liquid

specific gravity

0.890.01kg/L

Nonvolatile component

4±0.5%

viscosity

11±2S （-4 cups，25℃）

Construction parameters

Mix proportion

No thinner, direct spraying.

pot life

4 hours 25℃

Spraying viscosity

16~20 seconds（-4cups，25℃））

Spraying tool

Upper pot spray gun diameter of 1.2 ~ 1.5mm　 The lower pot nozzle diameter is 1.2 ~ 1.7mm

Spraying pressure

Gun pressure for 3-4KG/c㎡

Spraying method

Two layers of wet spraying, each layer of evaporation time for 5 ~ 10 minutes (20 ℃)

drying time

At 25 ℃, dry time 10 ~ 20 minutes.

Suitable substrate

Plastic parts（PE and Sensitive to solvent, except ps）

considerations

1：Direct use without thinner。 2：Suggest thin spray, if spray is easy to fall off。3：Use the back cover tightly to avoid the solvent volatilization result in the spray drawing again.

Packing specification

1L*12

storage

The storage period of the open tank is 2 years